LST Smoke Alarm AD 58000 400 User Manual

Thermal Detector

AD-58000-400

• ADM loop technology with

Apollo/Discovery protocol

• For use as maximum heat or

rate-of-rise heat detector

• 5 different operating modes

selectable

• Optional connection of remote

indicator

• Sealed electronics

Description

The addressable Thermal Detector AD-58000-400 is protocol establishes a permanent communication bet-

based on the heat principle and was developed for the ween the ﬁre detection control panel and the detector.

indoor temperature supervision in a wide range of ﬁre That ensures a periodical function testing of the detec-

detection applications.

tor. Fires are safely detected in the control panel by

continuously analysing the measured values.

Depending on the parameter setup in the ﬁre detection

control panel, the detector operates either as maximum The two LEDs with 360° visibility indicate the activated

heat detector with an alarm temperature of 61°C (EN condition of the detector. The detector address is se-

54-5 Class A2S) or 90°C (EN 54-5 Class CS), or as lected by means of a code card in the detector base.

rate-of-rise heat detector with a maximum temperature Therefore the detector can be changed without additi-

of 58°C (EN 54-5 Class A1R), 61°C (EN 54-5 Class A2) onal tools.

or 90°C (EN 54-5 Class CR). In Class A1R the detector

can be used up to a room height of 7.5m, in the other The detector can be attached to various bases and it

operating modes a room height of 6m is permissible.

The proven ADM loop technology with Apollo/Discovery

can be protected against theft.

Building Safety. Building Security.

AD-58000-400_DBL_LST_EN_0804.PDF • PAGE 1